Configure IP Interface for each VM

Getting Started with Napatech Link-Virtualization™ Software

Platform
Napatech SmartNIC
Content Type
Getting Started Guide
Capture Software Version
Link-Virtualization™ Software 4.4

Procedure

  1. Access each VM through the management port:
    ssh -p <port> localhost
    where:

    port is the number for the management port assigned when the VM was created.

    • 10021 is the port number for VM1
    • 10022 is the port number for VM2
  2. Inside the VM, list the network interfaces:
    ip link
  3. In the host1 VM, configure the OVS-connected Ethernet port with an IP address:
    Note: It is important that for each tenant each VM is configured with a unique IP address on the same IP subnet. Different tenants could use addresses from the same IP subnet since they are isolated on different integration bridges.
    Note: The following is an example IP address configuration.

    VM A1 (host1)

    ip addr add 10.1.1.11/24 dev <if>
    ip link set <if> up
    

    VM B1 (host1)

    ip addr add 10.1.1.21/24 dev <if>
    ip link set <if> up