Install and detect the Napatech SmartNIC using the lspci
command.
About this task
This describes how to detect the Napatech SmartNIC after installing the hardware.
Note:
Napatech Link-Inline™ Software supports a single
SmartNIC in the system.
Procedure
-
Install a Napatech SmartNIC in a server.
Refer to these documents for information on how to install a Napatech SmartNIC in a server:
-
Detect the SmartNIC using lspci with the Napatech vendor ID
18f4.
lspci -d 18f4:
An output
example:
42:00.0 Network controller: Napatech A/S NT200A02 Network Adapter
Note: Install the PCI utility package if it is not installed. For
example:
dnf install pciutils