Install an NT200A02-SCC Interconnect Solution

About this task

The solution is not hot-pluggable.

Note: The interconnect solution is not supported on the NT200A02-SCC Older Version.

Power off the server, and remove the server cover.

CAUTION:
Refer to the server documentation for correct procedure and for safety instructions.
Remove the SmartNICs from the ESD bags.

CAUTION:
Observe the ESD precautions detailed in ESD Precautions when handling or placing the SmartNIC on a surface.
Insert the SmartNICs in two vacant PCI Express ×16 connector, ensuring that it sits securely within the PCI Express connector.

Note: To optimize cooling, it is recommended that the two SmartNICs are inserted into slots with as much space between them as possible.
Interconnect the two SmartNICs:
1. Plug the interconnect cable into the expansion connector on both SmartNICs.
2. Locate the two tiny holes at either side of the expansion connector.
3. Install the cable retention clips by pressing each clip onto the PCB, as illustrated.