Plug In a Pluggable Module

NT20E3-2-PTP-NEBS Installation

Platform
Napatech SmartNIC
Content Type
Hardware Installation Guide

About this task

For information on modules that have been qualified by Napatech for use with the SmartNIC, see accessories.napatech.com.

Procedure

  1. If you want to avoid exposure to laser light, power off the server.
  2. Plug in the module, making sure that the latch is firmly secured.
    CAUTION:
    To avoid exposure to laser light, do not remove the protective plugs on the modules until the fiber optic cables are to be connected. Retain and replace the plugs if the cables are removed.
    ATTENTION :
    Pour éviter l'exposition à la lumière laser, ne pas enlever les bouchons de protection sur les modules jusqu'à ce que les câbles à fibres optiques soient connectés. Retenir et remplacer les bouchons si les câbles sont enlevés.
    ACHTUNG:
    Zur Vermeidung der Exposition zum Laserlicht, entfernen Sie nicht die schützenden Stecker auf den Modulen, bis die Glasfaserkabel angeschlossen werden müssen. Behalten Sie und ersetzen Sie die Stecker zu, wenn die Kabel entfernt werden.
  3. Use a fiber optics cleaning tool to clean the module and fiber optic connector terminal(s), and connect the fiber optic cable(s).
    Note: To reduce the possibility of a bad connection, it is essential that you clean the module and fiber optic connector terminal(s) every time before use.
  4. Power on the server.