General Specifications

NT50B01 Installation
Platform
Napatech SmartNIC
Content Type
Hardware Installation Guide

Network interface

Table 1. Network interface specifications
Characteristic Description

IEEE standards

IEEE 802.3 25 Gbit/s Ethernet

IEEE 802.3 10 Gbit/s Ethernet

Type of physical interface

 SFP28

Number of physical interfaces

 2 ports

Pluggable Modules

For information on modules that have been qualified by Napatech for use with the SmartNIC, see accessories.napatech.com.

Host interface

Table 2. Host interface specifications
Characteristic Description
Bus type PCI Express Gen3
Bus width 16-lane
Bus speed 8 GT/s
PCIe controller Based on a PCIe IP core integrated in the FPGA
Data transfer mode Memory write or memory read transactions
Data width Support for 32/64-bit addressing and data width
Interrupt Support for Message Signaled Interrupts (MSI) or legacy interrupts

Physical dimensions

Table 3. Physical dimensions
Characteristic Description
PCIe length 1/2-length
PCIe height Half-height
PCIe width Single-slot

The following figure illustrates the physical dimensions with the low-profile bracket.

Figure 1. Physical dimensions (low profile)
Page-1 Sheet.2

The following figure illustrates the physical dimensions with the high-profile bracket.

Figure 2. Physical dimensions (high profile)
Page-1 Sheet.2

This list shows the PCIe standard dimensions:

  • 1/2-length: 167.65 mm (6.600 inches)
  • Half-height: 68.90 mm (2.731 inches)
  • Single-slot:
    • Top: 14.47 mm (0.570 inches)
    • Bottom: 2.67 mm (0.105 inches)

Environment

Table 4. Environmental specifications
Characteristic Description

Operating temperature
–5 °C to 55 °C (23 °F to 131 °F) measured around the SmartNIC.
Note: The SmartNIC requires a laminar air flow along the board for operation up to 55 °C.

Operating relative humidity

5% to 85%

Compliances
  • NEBS Level 3
  • PCI-SIG®
  • CE (EU)
  • CB
  • RoHS
  • REACH
  • cURus(UL)
  • FCC (USA)
  • ICES (Canada)
  • VCCI (Japan)
  • RCM (Australia)

MTBF

Table 5. MTBF
Characteristic Description
MTBF 991,182 hours (113 years)
Standard According to UTE C 80-810

Electrical rating

This table shows the power consumption for an NT50B01 SmartNIC including 2 pluggable modules.

Table 6. Power consumption
Port Speed Power consumption [in W]
NT50B01 2 × 10 Gbit/s 25
NT50B01 2 × 25 Gbit/s 30

Power is measured with capture of a stream with 80% load of 300-byte frames. A sustaining load of 80% with 300-byte frames is representative for maximum real-life scenario.

The SmartNIC is Class III equipment for supply by SELV circuits only.

Port numbers

Table 7. Port numbers
Characteristic Description
Port numbers 0 and 1
Location Page-1 Sheet.8