The NT80E3-2-PTP SmartNIC operates at a maximum of 75 W. Accordingly, the SmartNIC must
either be installed in a PCIe generation 3 slot that supports this, or the auxiliary power
connector must be used for additional power supply (see Optional Auxiliary Power Connector Specifications).
See Electrical rating for details on power
The PCI Express connector in which the SmartNIC is inserted must physically be a 16-lane
Gen3 type connector.
The SmartNIC must be installed only in a server having adequate cooling air flow to
maintain the air temperature around the SmartNIC at or below 45 °C during operation. Avoid
installation in a slot adjacent to other high-temperature components. The I/O bracket must
not be blocked, preventing the fan from blowing air out of the cooling system.
The power consumption and thereby the heat dissipation depend on the SmartNIC activity. After a first installation in a new server, the ambient temperature should be verified by measurement while processing at full rate on all channels.
Note: Failure to observe these requirements might cause intermittent operation.
When installing the SmartNIC in the server, you must ensure that the SmartNIC is firmly secured in the PCI slot using the retention mechanism, for instance screw or clamp, provided in the server. In addition, you must ensure that the retention mechanism provides sufficient protection of the SmartNIC against excessive vibration stress during transport. If the retention mechanism is not sufficient, you must consider adding extra retention or other means of preventing vibration stress.
If these precautions are not respected, there is a risk of the SmartNIC being damaged due to vibration stress during transport of the server.