The Default ntpcap.ini File

libpcap Installation

product_line_custom
IntelĀ® PAC
Napatech SmartNIC
category
Software Installation Guide

Description

The default ntpcap.ini file creates 4 devices (if 4 ports are available), named napa0, napa1, napa2 and napa3. Each device has one filter assigned and both RX and TX capabilities.

Contents of ntpcap.ini

This is the contents of the default ntpcap.ini file:

Note: In version 1.7.3 or later a [Common] section must be added (see Format of the ntpcap.ini File).
# Napatech default ntpcap.ini file

# Note that you might have less than 4 ports on your system.
# If this is the case, then napa1 and/or napa2 and/or napa3 
# will be silently ignored when using this default config file.

[napa0]
Rx1="Assign[streamid=252;txport=0;txignore=true]=port==0"
Tx=0

[napa1]
Rx1="Assign[streamid=253;txport=1;txignore=true]=port==1"
Tx=1

[napa2]
Rx1="Assign[streamid=254;txport=2;txignore=true]=port==2"
Tx=2

[napa3]
Rx1="Assign[streamid=255;txport=3;txignore=true]=port==3"
Tx=3