Network interface
Characteristic | Description |
---|---|
IEEE standards |
IEEE 802.3 100 Gbit/s Ethernet |
Type of physical interface | QSFP56 |
Number of physical interfaces | 2 ports |
Supported pluggable modules |
QSFP28 |
Pluggable Modules
For information on modules that have been qualified by Napatech for use with the SmartNIC, see accessories.napatech.com.
Host interface
Characteristic | Description |
---|---|
Bus type | PCI Express Gen4 |
Bus width | 16-lane |
Bus speed | 16 GT/s |
PCIe controller | Based on a PCIe IP core integrated in the FPGA |
Data transfer mode | Memory write or memory read transactions |
Data width | Support for 32/64-bit addressing and data width |
Interrupt | Support for Message Signaled Interrupts (MSI) or legacy interrupts |
Physical dimensions
Characteristic | Description |
---|---|
PCIe length | 1/2-length |
PCIe height | Full-height |
PCIe width | Single-slot |
This list shows the PCIe standard dimensions:
- 1/2-length: 167.65 mm (6.600 inches)
- Full-height: 111.28 mm (4.381 inches)
- Single-slot:
- Top: 14.47 mm (0.570 inches)
- Bottom: 2.67 mm (0.105 inches)
Environment
Characteristic | Description |
---|---|
Operating temperature |
0°C to 45°C (32°F to 113°F) measured around the SmartNIC |
Operating relative humidity |
20% to 80% |
Compliances |
|
MTBF
Characteristic | Description |
---|---|
MTBF | 583,617 hours |
Standard | According to UTE C 80-810 |
Electrical rating
This table shows the power consumption for an NT400D11-SCC SmartNIC including 2 pluggable modules.
Port Speed | Power consumption [in W] |
---|---|
NT400D11-SCC 2 × 100 Gbit/s | 75 |
Power is measured with capture of a stream with 80% load of 300-byte frames. A sustaining load of 80% with 300-byte frames is representative for maximum real-life scenario. The actual power consumption depends on the FPGA software payload.
The SmartNIC is Class III equipment for supply by SELV circuits only.
Port numbers
Characteristic | Description |
---|---|
Port numbers | 0 and 1 |
Location |
|
RAM bank
Characteristic | Description |
---|---|
Memory | 12 GB DDR4 RAM |
Memory details | One standard 64-bit DDR4-2666 RAM bank |
Flash
Characteristic | Description |
---|---|
QSPI flash memory | 2 × 1024 Mbit |
Boot image | Support 2 boot images |
Expansion connector
The expansion connector is reserved for future use.
Characteristic | Description |
---|---|
Connector | One 16-lane HSEC8 expansion connector supporting 28.21 Gbit/s per lane bidirectional. This provides a total maximum bidirectional bandwidth of 902.72 Gbit/s. For information on available interconnect cables see DN-0515 on docs.napatech.com (the Napatech Documentation Portal). |
Location |
|