In this section
Note: This section only applies to NT200A02-2x40/8x10 SmartNICs with FM images.
Default image
By default the SmartNIC runs on the image in bank 0, which is the 2 × 40 Gbit/s image.
This is an example of an output from a --query command on a SmartNIC in default
mode.
imgctrl --adapter 0 --query imgctrl v3.10.1.3-1cb34 (Nov 27 2019 07:45:22) (Logfile: /tmp/imgctrl.log) Scanning for Napatech adapters.. Adapter 0: PCI SLOT : 0000:84:00.0 PCI DEVICE ID : 01C5 PCI LANES : x16 ADAPTER TYPE : NT200A02-01-SCC-2x40/8×10-E3-FF-ANL 2x40Gb QSFP+ platform RUNNING FPGA: FPGA IDENT : 200-9535-21-23-0000 DESCRIPTION : 2x40Gb, capture FPGA BANK0: PRODUCT CODE : 9535 VERSION : 21.23 DOWNLOADED BY : kje FPGA BANK1: PRODUCT CODE : 9534 VERSION : 21.24 DOWNLOADED BY : kje SUPPORTCHIP INFO: NT200A02 : v3.5q FPGA IMAGE STATE: IMAGE STATE : NEUTRAL (code 0) PRIMARY BANK : 0 RUNNING BANK : 0
Switching to 8 × 10 Gbit/s operation
The NT200A02-2x40/8x10 SmartNIC can be switched from 2 × 40 Gbit/s operation to 8 × 10 Gbit/s
operation as shown in this
example:
$ imgctrl --adapter 0 --switch $ imgctrl --adapter 0 --switch --confirm
The --switch command forces the SmartNIC to run on the 8 × 10 Gbit/s image. The --switch --confirm command changes the primary image to the running image, that is the 8 × 10 Gbit/s image in image bank 1.
This is an example of an output from a --query command after the
--switch command
above.
imgctrl --adapter 0 --query imgctrl v3.10.1.3-1cb34 (Nov 27 2019 07:45:22) (Logfile: /tmp/imgctrl.log) Scanning for Napatech adapters.. Adapter 0: PCI SLOT : 0000:84:00.0 PCI DEVICE ID : 01C5 PCI LANES : x16 ADAPTER TYPE : NT200A02-01-SCC-8×10/2x40-E3-FF-ANL 2x40Gb QSFP+ platform RUNNING FPGA: FPGA IDENT : 200-9534-21-24-0000 DESCRIPTION : 8x10Gb, capture FPGA BANK0: PRODUCT CODE : 9535 VERSION : 21.23 DOWNLOADED BY : kje FPGA BANK1: PRODUCT CODE : 9534 VERSION : 21.24 DOWNLOADED BY : kje SUPPORTCHIP INFO: NT200A02 : v3.5q FPGA IMAGE STATE: IMAGE STATE : NEUTRAL (code 0) PRIMARY BANK : 1 RUNNING BANK : 1